# SA30 build 705 version 1.33 **URL:** \ **Category:** Software\ **Tags:** firmware\ **Created:** [August 22, 2020, 5:41pm UTC](https://arcam.discourse.group/t/sa30-build-705-version-1-33/129 "2020-08-22T17:41:36Z")\ **Posts on this page:** 1\ **Showing post:** 69
**Author:** ![jvs1](https://yyz2.discourse-cdn.com/free1/user_avatar/arcam.discourse.group/jvs1/32/10_2.png) [@jvs1](https://arcam.discourse.group/u/jvs1)\ **Post date:** [October 8, 2020, 12:35pm UTC](https://arcam.discourse.group/t/sa30-build-705-version-1-33/129/69 "2020-10-08T12:35:58Z")
There are some remote related issues posted here. It is similar to one of the following issues? In some cases you have to press the AMP button first in order the SA30 responds to remote control commands. Hope this helps. The next one listed below occurs after you decrease the maximum allowed volume. > [@Volume +/- commands from the TV remote will require more presses, ref#34](https://arcam.discourse.group/t/volume-commands-from-the-tv-remote-will-require-more-presses-ref-34/16): > > Prerequisites HDMI cable is connected between Arcam SA30 and TV. Scenario Perform the following steps: switch on Arcam SA30 version 1.21 is used go to menu, audio settings, set ‘max volume’-setting to 20 watch some TV (TV is playing through SA30=ok) press volume increase button on TV remote Actual result It requires 5 presses on the TV remote to increase the volume level one level. Expected result Every button press on the TV remote should increase the volume level one level. This one occurs after you press the remote control button button multiple times. > [@SA30 remote: commands are ignored, ref#7](https://arcam.discourse.group/t/sa30-remote-commands-are-ignored-ref-7/25): > > If 2 commands with a very short time in between are performed then the first command is not executed. Scenario Press twice a single button on the SA remote quickly. Actual result If 2 commands with a very short time in between are performed then the first command is not executed. There seems to be a startup time frame in which some remote commands are not executed. Expected result Command executed on the remote should be executed immediately. All commands should be executed at any time O… --- _[View the full topic](https://arcam.discourse.group/t/sa30-build-705-version-1-33/129)._